We provide suitable accessories for your applications. Custom-made products and adapters are available on short notice.

Quick change inserts

  • sizes 0 – 2
  • to mount taps in quick change tapping chucks.
  • the selection of the taps results out of shank diameter and square

Feed system for spindle

  • ideally suited for solutions and automation
  • continuously adjustable limit for gating force with presentation in display
  • continuously adjustable speed of feed
  • damping for low tool wear
  • start by foot switch, sensor, or PLC interface start on adjustable release height for time saving

Foot switch, proximity switch for Feed system

  • foot switch in standard design
  • foot switch in robust design
  • inductive proximity switch with plug

Minimum lubricant / lubricant pulse unit

  • pneumatic 87psi / 6bar
  • dosage adjustable in the microliter range
  • 1 vent to control
  • without spray mist
  • time and pulse adjustable by user interface unit
  • very low usage of cooling lubricant

Minimum lubricant unit with lubricant pulse, air pulse, air cleaning pulse

Same as above with the addition of

  • air blow off for final cleaning after work process
  • air blow control in the chip cleaning work mode

Signal light column for quality evaluation

  • red, orange, green and horn
  • green means: quality good, work process without errors
  • orange means: machine is working
  • red and horn (short signal) means: errors occurred during work process

Key switch with lock-out

  • locks the user interface
  • locks the output signal of the clamping function in case of errors during work process

Push Button Access to Procedure Data Base

  • direct access to saved parameter sets, fast switch of tool, and assigning special functions